How to maintain the industrial cleaning machine?

In the intensive automotive and shredding repair market, customer service is critical - and quality service is often measured by timeliness and quality of repairs.

To complete repairs on time and to a high standard, each phase needs to run smoothly and efficiently. There is no room for equipment downtime or workflow interruptions.

That's where industrial parts washers come in. They are an integral part of an automotive or shredding repair shop. However, if they are not properly maintained and cared for, they are at risk of failure, which can cause delays and affect the quality of repairs.

This passage is going to talk about the followings of industrial cleaning machine:

1) What is a typical washer service task?

2) What can go wrong if you do not repair your machine?

3) What are the warning signs that your machine needs maintenance?

4) Conclusion

1) What is a typical washer service task?

Inspecting a parts washer service is a simple operation that can be performed by following these steps.

1.Check the operation of the machine. Is each component working properly? (e.g., is the basket turning, is there proper cleaning fluid flowing from the nozzles, etc.)

2.Clean the machine. These machines are exposed to oil and grease residue. They must be cleaned to prevent corrosion and to prevent the accumulation of waste inside the machine itself, which can eventually interfere with its operation.

3.Remove waste from the machines. Each machine has filters and waste collection containers. These must be cleaned thoroughly to ensure long-term operation.

4.Add new cleaning fluid to the cleaning machine.

5.Re-commission the machine and check operation again.

2) What can go wrong if you do not repair your machine?

Over time, you will experience a significant reduction in the efficiency of your machine. Parts will develop stubborn traces of dirt, oil and grease that remain deeply ingrained.

Just like a car, the performance of your industrial parts washer will deteriorate and eventually break down without repair.

Equipment failure is bad news for any automotive and shredding repair store. The cost of repairing a faulty machine is much higher than the cost of regular maintenance, and disruptions in workflow can lead to unhappy customers.

3) What are the warning signs that your machine needs maintenance?

It's important to monitor the performance of your industrial parts cleaning machine between services to spot warning signs before they become major problems. Here are some potential problems to look for.

The hot jet washer basket stops spinning.

Water does not heat up

Water stops flowing

Fluid-based parts cleaners stop draining

4) Conclusion

For more information on parts cleaning, contact us for equipment and services specifically for your automotive and repair parts cleaning needs. We offer industrial parts cleaning machines as standard to ensure your store is always operational. Our maintenance services give you peace of mind that your automotive and repair store will have the support it needs to keep you online.

ACME is a high-tech enterprise specializing in the development, design, manufacture and sales of automatic welding equipment. We mainly focus on the overseas market and meet the national standards of different countries. We not only provide various standard and non-standard welding equipment, including welding rotators welding positioners, welding manipulators welding robots, but also CNC flame cutting machines, CNC plasma cutting machines, CNC table cutting machines, shot blasting machines and cleaning machines. Our products are widely used in high-tech industries, such as offshore wind power generation onshore wind power generation, offshore shipbuilding pressure vessels, petrochemical industry, etc.